افتخار میکنیم که از سال ۱۹۶۴ مالکیت و اداره کانادایی داشتهایم.
1" x 6" Select Pine V4E T&G Soffit, Natural, 16 ft.
*فقط قیمتگذاری آنلاین
1" x 6" Select Pine V4E T&G Soffit, Natural, 16 ft.
1 x 6 select tight knot pine, kiln dried and milled tongue and groove with a V groove on both the face and the back. Sold as a natural, unprimed 16 ft. board. It blind nails through the tongue and shows a 5 in. face, so it suits soffits, porch ceilings and covered entries.
Protected exterior use only. This board is approved for soffits and covered ceilings, not for walls or surfaces open to weather. Need a wall profile? Contact us and we will point you to a wall siding profile.
Features and Common Uses
- Select tight knot pine, kiln dried
- V4E profile: V groove on the face and the back, tongue and groove edges
- 16 ft. natural, unprimed board
- 5 in. face covers 2.4 lineal feet per square foot
Commonly used for:
- Roof overhang soffits
- Porch and covered entry ceilings
- Stained natural wood ceilings under cover
Specifications
| Brand | Griff |
|---|---|
| Species and grade | Select tight knot pine, kiln dried |
| Profile | Tongue and groove, V4E (V groove on face and back) |
| Net size | 11/16 in. x 5-1/2 in. |
| Face width (coverage) | 5 in. |
| Coverage | 2.4 lineal ft. = 1 sq. ft. |
| Length | 16 ft. |
| Finish | Natural, unprimed |
| Approved use | Soffits and protected exterior ceilings |
How to Install
- Store boards indoors or under dry cover, off the ground with airflow, and acclimatize them for 5 to 7 days in the space where they will be installed.
- Confirm the framing, blocking or plywood is sound and dry, that attic or roof ventilation exists behind the soffit, and that rain or standing water cannot reach the boards.
- Cut from the finished face with a fine-tooth saw or a carbide-tipped blade, then prime or paint all field-cut ends before installing.
- Nail through the tongue at a slight angle with solid backing at every fastening point, using galvanized or stainless fasteners. Do not overdrive, and keep a consistent reveal at the joint.
- Finish every face, end and edge on site with the same number of coats on all sides. Use transparent or semi-transparent stains on natural boards.
Follow local building codes. Improper installation may void any product warranty.
Frequently Asked Questions
Is this board primed?
No. It is natural and unprimed, so it needs finishing on every face and cut end, see the install section.
How much does one 16 ft. board cover?
About 6.7 sq. ft. at the 5 in. face, based on 2.4 lineal feet per square foot.
Can I use it on a wall?
No. This product is limited to soffits and protected exterior ceilings, fully shielded from direct weather. Contact us for wall siding profiles.
How is it priced?
Each 16 ft. board is priced as one piece, not per lineal foot.
What stain or paint goes on natural boards?
Use transparent or semi-transparent stains on natural boards. Solid stains are acceptable only where vapor permeability is not critical.